User's Manual

DG-NGC WIRELESS I.GLOW CONTROLLER WITH LEDS

Instruction Manual

（English Version ）

E-CORE Technology (China) Co., Ltd

Thanks for selecting the GameCube wireless controller of RF 2.4GHZ

series producted by us ,in order to be more convenient and correct when

operating ,please read this intruction manual carefully !

Product introduction

GC wireless controlelr is adopting 2.4GHZ RF technology ,carrying the steady

connection ,far distance , low power wastage , beautiful outlook and nice

handle ,which make you experience personally when playing .

Technology Specification

1、Compatible with all the GameCube version console

2、Support TURBO function

3、Signal connection indication

4、Fixed ID codefunction

5、Low voltage indication

6、Automatically sleeping function to saving electricity

7、Skid-proof design to the grips

8、Available distance≥10 meters

9、Work voltage ：4.5V 3×1.5V AAA batteries

10.Automatically connection

11、Work current： 20mA Sleeping mode :100μA

12、Outlook size： Controller 150*100*65mm；receiver 28×36×

34mm

13、weight：169g

PAGE 1
DG-NGC WIRELESS I.GLOW CONTROLLER WITH LEDS Instruction Manual （English Version ） Thanks for selecting the GameCube wireless controller of RF 2.4GHZ series producted by us ,in order to be more convenient and correct when operating ,please read this intruction manual carefully ! Product introduction GC wireless controlelr is adopting 2.
PAGE 2
Product declaration : Product function declaration ： 10、 Using illustration 1）、Open the battery cover，install the 1.5V 3 AAA batteries in the battery case comply with the polarity ，then close the battery cover . 2）、Connect the GameCube with Televison Set ,put into game disk,then insert the receiver.
PAGE 3
work . 9）、Once the controller connect with the receiver normally ，you need not connect them by youself but just turn on the power switch then they will connect automatically later .
PAGE 4
(d) For systems incorporating serveral digital devices, the statement shown in paragraph (a) or (b) needs to be contained only in the instruction manual for the main control unit. FCC ID: SIWNC696A MADE IN CHINA This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.