Service manual

TRANSCEIVER PROGRAMMING
4-10
Revised December 2000
Part No. 001-9750-007
PTT Tone Delay Programming Screen
Linking Systems To A Bank
A system can be linked to a previously created
bank from the Create/Edit System screen as follows or
from the Create/Edit Bank screen described in Section
4.3.6. To do this, proceed as follows:
a. When system information is being programmed, the
current banks are displayed on the right side of the
screen. If the current system is in a bank, there is a
system number to the right of the bank name. If it is
not in the bank, “xx” is indicated.
b. To add or delete the current system, press the F5 key
and then use the arrow keys to highlight the desired
bank. To add the current system to that bank, press
the “A” key; to delete it from that bank, press the
“D” key.
c. If a system was added, the highlight bar moves to
the system number column. This column programs
the number of that system in the displayed bank.
Enter the desired number from 1-99. Press the
Return key once to make the change and press it
again to go back to editing system information.
Programming System Universal Interface Options
To display the screen that programs the Universal
Interface parameters for the system, press the F4 key.
Refer to Section 4.7 for more information on
Universal Interface programming.
4.3.6 CREATE/EDIT/COPY/DELETE BANK
Create Bank
This Create Bank function is used to create a new
bank. At least one bank must be created even if banks
are not going to be selected. Banks are identified by
alpha tag and selected by the BANK option switch or
“Bank Select” Menu Mode parameter. An alpha tag
can have up to ten characters. Most printable ASCII
characters can be used except the following:
# & ( ) , . : ; [ ]
After the alpha tag is entered, the Create/Edit
Bank screen is displayed. This screen is used to edit
information unique to a bank. This screen and the
parameters it programs are described in Table 4-5.
Edit Bank
The Edit Bank function is used to change parame-
ters of previously created banks. The bank to be edited
is selected from a list of the current banks, and the
arrow and Return keys are used to select the desired
bank. The Create/Edit Bank screen is then displayed
(see preceding “Create Bank” description).
Copy Bank
This screen is used to create a new bank by
copying information from another bank. The bank to
be copied is selected from a list and then the alpha tag
for the new bank is entered. This does not copy
anything to a disk file; only to another bank in the
buffer.
Delete Bank
This function is used to delete a current bank. The
bank to be deleted is selected from a list. This does not
delete anything on disk; only the selected bank in the
buffer.
Linking Systems To A Bank
Systems are created using the Create System
screen or Copy System functions. The programmed
systems can then be linked to a bank from either the