Service manual

OPERATION
2-4
November 2001
Part No. 001-7240-001
Dial Mode
RCL - After recalling a number, scrolls through
other numbers programmed in memory.
FCN RCL (0-9) - Recalls the number stored in the
specified memory location.
FCN RCL - Recalls the last number recalled
from memory.
FCN RCL - Recalls the last number sent by FCN
SND.
GRP (CLR)
Standard Mode
The GRP key changes or displays the selected group
similar to the “SYS” key just described.
Dial Mode
CLR - Erases the last digit in the display.
FCN CLR - Erases the entire number in the display.
1 (HOME)
Standard Mode
FCN HOME - Selects the pre-programmed home
system/group.
1 - Pressing this key with the PTT switch pressed
transmits the “1” digit.
Dial Mode
1 - Dials the “1” digit.
2 (PHONE)
Standard Mode
FCN PHONE - Selects the dial mode and the first
telephone group in the current system.
2 - Pressing this key with the PTT switch pressed
transmits the “2” digit.
Dial Mode
2 - Dials the “2” digit.
FCN PHONE - Exits the dial mode and sends the
call termination characters.
3 (DIAL)
Standard Mode
FCN DIAL - Selects the dial mode without
changing the currently selected group.
3 - Pressing this key with the PTT switch pressed
transmits the “3” digit.
Dial Mode
3 - Dials the “3” digit.
FCN DIAL - Exits the dial mode without sending
the call termination characters.
4 (PAGE)
Standard Mode
FCN PAGE - The page function is currently not
available.
4 - Pressing this key with the PTT switch pressed
transmits the “4” digit.
Dial Mode
4 - Dials the “4” digit.
5 (MENU)
Standard Mode
FCN MENU - Selects the menu mode (Section
2.5.2).
5 - Pressing this key with the PTT switch pressed
transmits the “5” digit.
Dial Mode
5 - Dials the “5” digit.
6 (SQL)
Standard Mode
FCN SQL - Selects the squelch adjust mode for
conventional channels (Section 2.11.4).
6 - Pressing this key with the PTT switch pressed
transmits the “6” digit.
Dial Mode
6 - Dials the “6” digit.
7 (S.A/D)
Standard Mode
FCN S.A/D (System Add/Delete) - Changes the
scan list status of the currently displayed system.
The system is in the scan list and scanned
normally if “ ” is displayed when not scanning.
7 - Pressing this key with the PTT switch pressed
transmits the “7” digit.
Dial Mode
7 - Dials the “7” digit.
8 (SEND)
Standard Mode
8 - Pressing this key with the PTT switch pressed
transmits the “8” digit.
#
S