Service manual

PROGRAMMING
3-6
November 2001
Part No. 001-7240-001
and exit, or click the Cancel button to exit without
saving any changes.
3.4.5 SYSTEM PROGRAMMING
Each system is linked to one of the localities.
Therefore, at least one locality must be created as just
described before systems can be created. Groups are
added to the systems by group programming described
next. Proceed as follows (Section 3.6.9):
Create New System
- Select Edit > Systems >
Create New or click in the toolbar.
Copy System
- To copy a system that is already
created for use as a basis in programming another,
select Edit > Systems > Copy Existing or click
in the toolbar.
Delete System
- Select Edit > Systems > Delete or
click in the toolbar.
When all parameters in the System screen are
programmed, click the OK button to save the changes
and exit, or click the Cancel button to exit without
saving any changes. Repeat this procedure to add
additional systems.
3.4.6 GROUP PROGRAMMING
Each group is linked to one of the systems.
Therefore, at least one system must be created as just
described before groups can be created. Groups
program individual call parameters. Proceed as
follows (Section 3.6.10):
1. To create a new group or edit a group, select Edit >
Groups or click in the toolbar.
2. A screen is then displayed which lists all current
systems. Select the system to which a group is be
added or in which a group is to be edited. Click the
OK button to display the groups in that system.
3. In the Group No. box, select the number or the
group to be added, edited, or deleted.
4. Program the group with the desired parameters.
5. Click the Add button if adding a new group, the
Change button if editing a group, or the Delete
button if deleting a group. To exit without saving the
current changes, click only the Done button.
6. Repeat until the system has been programmed with
the desired groups. Then click the Done button to
exit. Repeat to program other systems if applicable.
3.4.7 BANK PROGRAMMING
At least one locality, system, and group must be
programmed before a bank can be programmed. Banks
are collections of systems that may be selected for a
unique application such as operation in different
geographical areas. System numbering and other
parameters can be different for each bank. At least one
bank must always be programmed even if bank select
is not used.
1. Create, Edit, or Delete a bank as follows:
Create a New Bank
- Select Edit > Banks > Create
New or click in the toolbar.
Edit Bank
- Select Edit > Banks > Edit Existing or
click in the toolbar.
Delete Bank
- Select Edit > Banks > Delete or click
in the toolbar.
2. When the bank programming screen is displayed,
select the display number of the system to be added,
edited, or deleted. Then select the system to be
assigned to that number if applicable. Also program
default scan list status of the system and other bank
information such as alpha tag and emergency and
home system/group if applicable.
3. To make the selected changes to the system, click
the Add, Change, or Delete button, whichever is
applicable. To add, edit, or delete other systems,
repeat this procedure. When finished programming
the bank, click the Done button, or to exit without
making any changes, click the Cancel button.
3.4.8 PROGRAMMING TRANSCEIVER
When all the programming described in the
preceding sections is complete, the data is ready to be
downloaded to the transceiver as follows: