User's Manual

PULL DOWN MENUS
4-2
May 2000
Part No. 001-2008-204
4.2.4 NEW
This menu selection erases all Site and Repeater
information in the programmer and loads factory
defaults. If the current data has been changed, select-
ing File -> New provides the opportunity to save the
data before loading the defaults.
4.2.5 PRINT REPEATER CONFIGURATION
Select the destination for the configurations.
Printer - Prints to printer connected to PC.
File - Writes printable test to selected filename.
Select which repeater data will be printed.
All Repeaters - Prints the data for all valid
repeaters.
Single Repeater - Prints the data for the entered
repeater number.
NOTE: A list of valid repeaters can be seen under the Edit-
Select Repeater menu selection.
4.2.6 DOS SHELL
DOS shell temporarily suspends the program and
returns to DOS. Directories and other DOS com-
mands can be performed. To return to the program
from DOS, type EXIT and press Enter.
4.2.7 QUIT (ALT X)
Quit exits the repeater program and returns to
DOS. Save all files before exiting the repeater pro-
gram.
Figure 4-4 EDIT PROGRAMMING FLOWCHART
Repeater Number
Channel Number
Standalone
CWID Time
CWID Message
Local Mic ID
Test Mode ID
Default
Repeater Number
Input Alarms
Output Alarms
Cross Reference
Input Type Selection
Output Type Selection
Select Repeater
Alarm Configuration
EDIT
Setup Parameters F4
Alarm Cross Reference Selection
Delete Repeater
Repeater Type
Power Source
RF Power Level
Multi-Net
LTR
Universal Station
Frequency Band
Power Level
85W
800 MHz
800 MHz (-12.5 kHz)
900 MHz
Paging
Repeater Type
IAC Type
8 I/O IAC
4 I/O IAC
TELCO Network Type
Area
Data Modem
Telephone Access Parameters
Telephone Interface
TIC Calibration Data
175W