User's Manual

PULL DOWN MENUS
4-8
May 2000
Part No. 001-2008-204
4.5.4 REVISION/VERSION
The Revision/Version is displayed for the
repeater modules in this screen. The format is R.V
(revision.version) for all modules. The MPC informa-
tion also includes the release date of the software and
the serial number of the repeater.
Figure 4-23 REVISION/VERSION
4.5.5 MODE SELECT
The Mode Select screen places the repeater either
in the Normal mode or the Test mode. In the Normal
mode the repeater operates as a normal repeater.
In the Test mode the repeater transmits a test
word. This test word is the Test Mode ID setup in the
Setup Parameters (see Section 4.3.1
).
C A U T I O N
While in the test mode the repeater is "busy",
therefore it is important to place the repeater
in Normal mode when the test mode is no
longer required.
Figure 4-24 TEST PROGRAMMING FLOWCHART
All Test
Frequency Adjust
PA
TEST
Select Line Type
Data Over Voice (2-Wire)
All Receive Tests
All Transmit Tests
All Audio/Data Tests
All Operational Tests
Separate Data (4-Wire)
RS-2332
New HSDB Test
Old HSDB Test
Handshake Test
Alarm Test
Spurious Check
Voice Audio From Repeater
Voice Audio To Repeater
FSK Data To Rptr (Separate Path)
FSK Data To Rptr (Over Voice Path)
FSK Data From RNT (Separate Path)
FSK Data From Rptr (Over Voice Path)
RS-232 Setup
Audio Deviation Limit
Repeat Audio Level
Data Level Adjust
Audio/Data Deviation
CWID Level Check
Local Speaker/Mic
Tx Hum & Noise Ratio
Transmit Audio Distortion
LTR Modem
Power Output Adjust
TCXO Frequency Adjust
Audio Distortion
Hum & Noise Measurement
SINAD Measurement
Squelch Adjust
Data Level Adjust
Local Speaker/Mic
Desense Check
Miscellaneous Tests
Repeater Setup
Transmitter Tests
Receiver Tests
Transmit Audio/Data
Voter Audio Adjust
Audio/Data Adjust
Repeater Operation
Adjust Links
Receiver
Exciter
Full Rptr/Station
RNT Interface
Telephone Interface