User's Manual

PULL DOWN MENUS
4-9
May 2000
Part No. 001-2008-204
4.6 TEST
Figure 4-25 TEST MENU
4.6.1 POWER AMPLIFIER
This menu selection walks through the alignment
of the Power Amplifier and RF Interface Board on the
computer screen. Refer to Sections 7.3 and 7.4 for the
PA and RFIB alignment in this manual and Figures 7-
3, 7-6, 7-4 and 7-7 for an alignment points diagram
and Figures 7-10 and 7-11 of the Power Amplifier.
4.6.2 RECEIVER
This menu selection walks through the alignment
of the receiver on the computer screen. Refer to Sec-
tion 7.1 for the Receiver alignment in this manual and
Figure 7-1 for an alignment points diagram and
Figure 7-8 of the Receiver.
4.6.3 EXCITER
This menu selection walks through the alignment
of the Exciter on the computer screen. Refer to Sec-
tion 7.2 for the Exciter alignment and Figure 7-2 for
an alignment points diagram and Figure 7-9 for a test
setup of the Exciter.
4.6.4 FULL REPEATER
This menu selection walks through the alignment
of the entire repeater. The Receiver and Exciter por-
tions are performance tests and adjustments. The
Audio and Data portions are level adjustments for the
Main Audio Card (MAC). Refer to Figure 7-18 for an
alignment points diagram for the MAC.
4.7 UTILITIES
4.7.1 COM PORT
This is the COM port used to send and receive
data from the Repeater MPC. An interface cable con-
nects the Repeater to the computer (see Figure 4-26).
This screen also selects the data baud rate.
Figure 4-26 LAPTOP CABLE
4.7.2 DISPLAY MODE
This screen allows the color mode to be selected
for color monitors. When using a laptop, monochrome
is recommended for better resolution.
4.7.3 USER LEVEL
There are two levels to choose from, Novice and
Advanced. The Novice uses prompts in the Edit-
Parameters screens when Escape or F2 keys are
pressed that ask "are you sure" before the task is exe-
cuted. The Advanced selection performs the task
without asking the question.
Select COM Port Desired
Spacebar to Select
( ) COM 1 ( ) COM 2
Baud rate: 9600
TO MPC
TO LAPTOP
Spacebar to Select
Select Color Mode Desired
( ) Color ( ) Monochrome