User's Manual

INTRODUCTION AND OPERATION
1-2
May 2000
Part No. 001-2008-204
1.5 ACCESSORIES
The accessories available for the Viking VX LTR
repeater are listed in Table 1-1. A brief description of
some of these accessories follows.
2000 Series Service Kit- This kit includes an extender
card, extender cables, TIC bias cable and programming
cable. These items are used when tuning the repeater
and while troubleshooting.
Battery Backup Option - It includes the +26V DC
battery backup module that resides in the power supply
and the necessary interconnect cabling to connect the
repeater to the batteries (see Section 2.5).
Companding Module - This enhances the receive and
transmit audio when used in conjunction with the Tele-
phone Interface Card (TIC).
Three Foot Cable - This is a 3’ RG-58 coax cable with
BNC male connectors for the HSDB (High Speed Data
Bus).
Six Foot Cable - This is a 6’ RG-58 coax cable with
BNC male connectors for the HSDB (High Speed Data
Bus).
Custom Frequency - This is a factory frequency pro-
gramming and repeater setup.
PGMR 2000 Programming Software - 3.5" program-
ming disk used to program the repeater.
Service Microphone - This is a speaker and micro-
phone combination that plugs into the MAC connec-
tors. The microphone provides local audio and push-
to-talk, while the speaker provides local audio adjusted
with the volume control.
Table 1-1 ACCESSORIES
Accessory Part No.
2-Wire Telephone Interface Card (TIC) 023-2000-370
LTR System ID Validator 023-4408-500
2000 Series Service Kit
1
250-2000-230
Battery Back-Up Option
2
023-2000-835
3’ RG-58 BNC M-M HSDB cable 023-4406-505
6’ RG-58 BNC M-M HSDB cable 597-3001-214
Custom Frequency Programming & Setup 023-2000-100
PC Programmer PGMR Software 023-9998-297
Programming Cable Kit 023-2000-195
Service Microphone 589-0015-011
50 ohm Termination HSDB 023-4406-504
RJ-11 to RJ-11 cable 597-2002-200
Telewave Combining Systems High Power
5-channel 115V AC
3
585-1157-135
5-channel 230V AC
3
585-1157-145
Telewave Combining Systems Low Power
3-channel 115V AC
4
250-2008-054
3-channel 230V AC
4
250-2008-064
5-channel 115V AC
5
250-2008-055
5-channel 230V AC
5
250-2008-065
5-channel 115V AC
6
250-2008-050
5-channel 230V AC
6
250-2008-060
10-channel 115V AC
7
250-2008-051
10-channel 230V AC
7
250-2008-061
15-channel 115V AC
8
250-2008-052
15-channel 230V AC
8
250-2008-062
20-channel 115V AC
9
250-2008-053
20-channel 230V AC
9
250-2008-063
Duplexer (high power only) 585-1157-101
RF Lightning Protector
10
Type N lightning arrestor (low pwr only) 585-0898-001
Polyphaser 585-0898-003
Floor Mount 19 Open Rack
11
7’ with accessories, setup and test 023-2000-216
7’ 6 with accessories, setup and test 023-2000-217
8’ with accessories, setup and test 023-2000-218
AC Power Distribution
AC Power Strip 115V AC
12
597-1004-010
AC Power Stirp 230V AC
12
023-2000-212
1
Includes: extender card, extender cables, TIC bias cable
and programming cable kit.
2
+26V DC input with cable
3
2-antennas and 1-rack.
4
1-antenna and 1-rack (single rack configuration)
5
1-antenna/1-8 rack (single rack configuration)
6
1-antenna/1-additional rack (combining rack included)
7
1-antenna/2-additional racks (combining rack included)
8
2-antennas/3-additional racks (combining rack included)
9
2-antennas/4-additional racks (combining rack included)
10
1-lightning protector per antenna.
11
Accessories include all mounting hardware, rack ground
bar and wire to repeaters.
12
1-per 3 repeaters Low Power
1-per 2 repeaters High Power
Table 1-1 ACCESSORIES
Accessory Part No.