User Manual Part 2

SECTION 6 ALIGNMENT PROCEDURE

6.1 GENERAL

6.1.1 INTRODUCTION

The following alignment procedure should be performed if repairs are made that could affect the

factory alignment or if adjustments may have changed for some other reason. To verify radio

operation, the performance tests in Sections 6.5 and 6.6 can be run. To perform transceiver

alignment, the following are required:

• PC-compatible computer

• Remote Programming Interface (RPI), Part No. 023-5300-000.

• PCTune software, Part No. 023-9998-499.

All adjustments are set digitally using the computer. Therefore, there is no need to disassemble

the transceiver to access adjustment points. In addition, audio test signals are generated internally,

so an audio generator is not required. The required test equipment is shown in Figure 6-1.

6.1.2 TUNE SOFTWARE

General

The PCTune software is a Windows

® program. Minimum software and hardware requirements

are as follows: