User Manual Part 2

58
(9600/ 19200) used for communication with the radio. Select the computer port to which the test
cable is connected (see Section 6.4.1), and 19200 baud is normally selected. These parameters
default to the last selected condition the next time the program is started.
Read Tune Parameters - Selecting this function or clicking the
button reads the tune
parameters currently programmed in the transceiver and displays them in the various screens.
NOTE: Values in the various screens are for reference only and adjustments should be done only
by using the Partial Tune function.
Write Tune Parameters - Selecting this function or clicking the
button writes the current
tune parameters to the radio. This occurs automatically when a Partial Tune adjustment is
completed.
Tune Complete – Not available. This function automatically steps through all the tests required
to tune the radio.
Tune Partial - Selecting this function or clicking the
button selects the Partial Tune mode.
This mode automatically steps through all the adjustments of the currently selected Tune
Category.
6.3.4 TOOLS MENU
Reset Radio - Resets the radio control logic similar to cycling power. This can be used, for
example, to change the radio series or band or exit an adjustment before it is complete.
Set Band - Selects the operating band of the radio. All tuning values are reset to the factory
defaults.