Operating Manual
Table Of Contents
- SAFETY TRAINING INFORMATION
- FEATURES
- TABLE OF CONTENTS
- OPTION SWITCH FUNCTIONS
- CONTROLS AND DISPLAY
- GENERAL OPERATION
- CONVENTIONAL FEATURES
- Introduction
- Display Mode Selection
- Monitoring Before Transmitting
- Monitor Mode
- Busy Channel Lockout
- Call Guard Squelch
- Penalty Timer
- Conversation Timer
- Repeater Talk-Around
- Power Output Select
- Emergency Mode (Conventional)
- Conventional Mode Scanning
- Priority Channel Sampling
- Placing and Receiving Standard Conventional Calls
- DTMF/ANI Signaling
- Project 25 Mode Features
- Keypad Programming
- Channel Parameter Programming
- SMARTNET/SMARTZONE FEATURES
- MISCELLANEOUS
- INDEX
CONTROLS AND DISPLAY
17
Display
The front panel display is shown above, and the following informa-
tion is indicated:
Alphanumeric Characters - This area of the display indicates the
selected channel, error conditions, and other information.
Sec - Indicates that transmissions are encrypted (see page 28).
Dig - Indicates that a digital (Project 25) conventional channel is selected.
Rx - Indicates that a carrier is being detected on the selected or scanned
channel.
Tx - Indicates the transmitter is keyed.
Pgm - Indicates that the keypad programming mode is selected (see
page 40).
SL - Indicates that the displayed channel is in the scan list (see page 25).
Pri - Indicates that the displayed channel is programmed as the current
group’s priority channel (see page 36).
Sec Dig Rx
Tx Pgm
SL
Pri
Call ID
Scan
Alphanumeric Display