Operating Manual

SMARTNET/SMARTZONE FEATURES
49
2. Using the 0-9 keys, enter the ID (all six digits) of the mobile unit you
are calling. To erase the last digit, press the Down switch, and to cancel
the call, press the
F3 key.
3. Press the PTT switch to initiate the call. If the entered ID did not contain
six digits, “INVALID” is momentarily displayed, an error tone sounds,
and the call is not initiated. If the entered ID is valid, the display indi-
cates the alias of the ID if it matches an ID in your call list. Otherwise,
the ID you entered continues to be displayed. Any of the following
conditions may then occur:
• If the radio you are calling is on the air, “WAIT” is displayed and tele-
phone type “ringing” is heard for 20 seconds or until the called party
answers.
• If the called party answers and the call is successful, the person’s
voice is heard and the call is carried on the same as a group call. To
end the call at any time, press the
F3 key.
• If the called party does not answer within 20 seconds, “NO ANS” is
displayed and a continuous tone sounds. End the call by pressing the
F3 key.
• If the called radio is not in service, no ringing is heard, “NO ACK” is
displayed, and a continuous tone sounds. End the call by pressing the
F3 key.
• If neither your radio nor the radio being called is authorized to make
unit-to-unit calls, “REJECT” is displayed and a continuous tone
sounds. End the call by pressing the
F3 key.
• If the called party answers but the radio system is busy, four low tones
sound and “BUSY” is displayed. When the system is no longer busy,
the call back tone sounds.
• If in the secure mode and your transceiver does not have the proper
encryption key, “KEYFAIL” is displayed and the call must be made