Operating Manual

SMARTNET/SMARTZONE FEATURES
52
Direct Entry Method (Full Keypad Models Only)
1. With a SMARTNET/SmartZone channel selected, press and hold the
Private Call option switch until a tone sounds (approximately 1
second). The last ID called is displayed.
2. Using the 0-9 keys, enter the ID (all six digits) of the mobile unit you
are calling. To erase the last digit, press the Down switch, and to cancel
the call, press the
F3 key.
3. Press the PTT switch to initiate the call. If the entered ID did not contain
six digits, “INVALID” is momentarily displayed, an error tone sounds,
and the call is not initiated. If the entered ID is valid, the display indi-
cates the alias of the ID if it matches an ID in your call list. Otherwise,
the ID you entered continues to be displayed. Any of the following
conditions may then occur.
• If in the secure mode and your transceiver does not have the proper
encryption key, “KEYFAIL” is displayed and the call must be made
in the clear mode (selected by the Clear/Secure option switch if
enabled on the channel).
• If the called party answers and the call is successful, the person’s
voice is heard and the call is carried on the same as a group call. To
end the call at any time, press the
F3 key.
• If the radio system is busy, four low tones sound and the “BUSY” is
displayed. When the system is no longer busy, the call back tone (four
beeps) is heard and a channel is automatically acquired. Press the PTT
switch to continue the call.
Receiving a Private Conversation II Call
Unit-to-unit calls are automatically received if a SMARTNET/
SmartZone channel is selected. Proceed as follows:
1. When a call is received, an alert tone sounds and the caller’s voice is
heard. While voice is heard, “CALL” is displayed.