Operating Manual
Table Of Contents
- SAFETY TRAINING INFORMATION
- FEATURES
- TABLE OF CONTENTS
- OPTION SWITCH FUNCTIONS
- CONTROLS AND DISPLAY
- GENERAL OPERATION
- CONVENTIONAL FEATURES
- Introduction
- Display Mode Selection
- Monitoring Before Transmitting
- Monitor Mode
- Busy Channel Lockout
- Call Guard Squelch
- Penalty Timer
- Conversation Timer
- Repeater Talk-Around
- Power Output Select
- Emergency Mode (Conventional)
- Conventional Mode Scanning
- Priority Channel Sampling
- Placing and Receiving Standard Conventional Calls
- DTMF/ANI Signaling
- Project 25 Mode Features
- Keypad Programming
- Channel Parameter Programming
- SMARTNET/SMARTZONE FEATURES
- MISCELLANEOUS
- INDEX
SMARTNET/SMARTZONE FEATURES
55
• If the selected number is not valid, “INVALID” is momentarily
displayed, an error tone sounds, and the call is not initiated. Select a
valid number.
• If enabled by system operator programming, a number can be dialed
during a call by simply holding down the PTT switch and dialing the
number.
• If an out-of-range condition exists or the radio system is not in
service, “NO PHONE” is displayed and a continuous tone sounds.
End the call by pressing the
F3 key.
• If you are not authorized to make telephone calls, “REJECT” is
displayed and a continuous tone sounds. End the call by pressing the
F3 key.
• If the radio system is busy, “BUSY” is displayed and a busy tone
sounds. The call automatically proceeds when the radio system
becomes available. If the call is ended before it proceeds, your
position in queue is lost.
• If in the secure mode and your transceiver does not have the proper
encryption key, “KEYFAIL” is displayed and the call must be made
in the clear mode (selected by the Clear/Secure option switch if
enabled on the channel).
Answering a Telephone Call
Telephone calls are automatically received if a SMARTNET/
SmartZone channel is selected. Proceed as follows:
1. When a telephone call is received, “ringing” similar to a standard tele-
phone is heard and the display indicates “PHONE”.
2. To answer the call, press the Phone option switch and then press the
PTT switch to talk and release it to listen.