Operating Manual

SMARTNET/SMARTZONE FEATURES
57
3. Press the PTT switch to send the page. If the entered ID is invalid,
“INVALID” is momentarily displayed and the page is not sent. If the
entered ID is valid, the display indicates the alias of the ID if it matches
an ID in your call list. Otherwise, the ID you entered continues to be
displayed. The page is then sent and any of the following conditions
may then occur.
• If the radio you are paging is on the air and received your page, a
signaling success tone (six beeps) sounds. The alias of the selected
channel is then displayed continuously.
• If the radio you are paging is not in service, a tone sounds and “NO
ACK” is displayed after trying for 6 seconds. Press the
F3 key to cancel
the page or try again.
Answering a Page
1. When a page is received, the display indicates “PAGE” and a recurring
received page tone sounds (five beeps) sounds.
2. To clear and ignore the page, press the
F3 key. NOTE: If the F3 key is
programmed for the Private Call function, it will not clear the page.
3. Answering a page is the same as placing a private call. Therefore, press
the Private Call option switch and follow the instructions for placing a
private call on page 48 or page 51, whichever is applicable.
Messaging
The messaging feature allows preprogrammed messages to be sent
to your dispatcher. Up to 16 messages can be preprogrammed, and they
are identified by a tag (alias). If a Message option switch is programmed,
messages are sent as follows:
1. Momentarily press the Message option switch. The alias of the last
message sent is displayed.