Operating Manual
Table Of Contents
- SAFETY TRAINING INFORMATION
- FEATURES
- TABLE OF CONTENTS
- OPTION SWITCH FUNCTIONS
- CONTROLS AND DISPLAY
- GENERAL OPERATION
- CONVENTIONAL FEATURES
- Introduction
- Display Mode Selection
- Monitoring Before Transmitting
- Monitor Mode
- Busy Channel Lockout
- Call Guard Squelch
- Penalty Timer
- Conversation Timer
- Repeater Talk-Around
- Power Output Select
- Emergency Mode (Conventional)
- Conventional Mode Scanning
- Priority Channel Sampling
- Placing and Receiving Standard Conventional Calls
- DTMF/ANI Signaling
- Project 25 Mode Features
- Keypad Programming
- Channel Parameter Programming
- SMARTNET/SMARTZONE FEATURES
- MISCELLANEOUS
- INDEX
MISCELLANEOUS
63
• Dynamic regrouping has been exited but the dynamic regrouping
channel is still selected (page 60).
• The paged mobile did not acknowledge the page (page 56).
• The message that was sent has not been acknowledged (page 57).
• The status condition that was sent has not been acknowledged
(page 58).
Single Short Medium-Pitch Tone
• A valid key has been pressed.
Single Short Low-Pitch Tone
• An invalid key has been pressed.
Six Beeps (Recurring)
• The page was received (page 56).
Three Beeps (Recurring)
• A unit-to-unit call was received (page 47).
Six Beeps
• The paged radio received the page and acknowledged it (page 56).
• The message that was sent has been received and acknowledged
(page 57).
• The status condition that was sent has been received and acknowledged
(page 58).
Two Beeps
• The emergency alarm condition was acknowledged (page 58).
Gurgle-Like Tone
• Dynamic regrouping has occurred (page 60).