Operator's Manual
Table Of Contents
- SAFETY TRAINING INFORMATION
- FEATURES
- TABLE OF CONTENTS
- OPTION SWITCH FUNCTIONS
- CONTROLS AND DISPLAY
- GENERAL OPERATION
- CONVENTIONAL FEATURES
- Introduction
- Display Mode Selection
- Monitoring Before Transmitting
- Monitor Mode
- Busy Channel Lockout
- Call Guard Squelch
- Penalty Timer
- Conversation Timer
- Repeater Talk-Around
- Power Output Select
- Emergency Mode (Conventional)
- Conventional Mode Scanning
- Priority Channel Sampling
- Placing and Receiving Standard Conventional Calls
- DTMF/ANI Signaling
- Project 25 Mode Features
- Keypad Programming
- Channel Parameter Programming
- SMARTNET/SMARTZONE FEATURES
- MISCELLANEOUS
- INDEX
GENERAL OPERATION
25
• If the zone or channel is changed while radio wide scanning, scanning
continues normally.
Scan Resume Delay
When a message is received or transmitted while scanning, there is a
system operator programmable delay before scanning resumes. The delay
after receiving a call prevents another message from being received
before you can make a response, and the delay after transmitting a call
ensures that you hear a response to your call instead of another message
occurring on some other channel.
Standard Mode Scan List
NOTE: The selected channel is always scanned.
With conventional operation, up to three scan lists can be
programmed. The list that is scanned is selected by the Scan option
switch as described on page 35. Selecting another conventional channel
does not change the current scan list. The scan lists are user program-
mable if the Scan Edit option switch is programmed (see page 26).
With SMARTNET/SmartZone operation, each channel can be
programmed so that one of up to three different scan lists is automatically
selected or scanning is disabled. The scan list assigned to the current
channel is not user selectable, but it is user programmable if the Scan Edit
option switch is programmed (see page 26).
Radio Wide Mode Scan List
With radio wide scanning, there is only one preprogrammed scan list
available regardless of the type of channel selected, and it is not user
programmable.
Determining Which Channels are in Scan List
Channels in the standard SMARTNET/SmartZone and radio wide
lists are not indicated. With conventional channels, the selected channel