Operator's Manual
Table Of Contents
- SAFETY TRAINING INFORMATION
- FEATURES
- TABLE OF CONTENTS
- OPTION SWITCH FUNCTIONS
- CONTROLS AND DISPLAY
- GENERAL OPERATION
- CONVENTIONAL FEATURES
- Introduction
- Display Mode Selection
- Monitoring Before Transmitting
- Monitor Mode
- Busy Channel Lockout
- Call Guard Squelch
- Penalty Timer
- Conversation Timer
- Repeater Talk-Around
- Power Output Select
- Emergency Mode (Conventional)
- Conventional Mode Scanning
- Priority Channel Sampling
- Placing and Receiving Standard Conventional Calls
- DTMF/ANI Signaling
- Project 25 Mode Features
- Keypad Programming
- Channel Parameter Programming
- SMARTNET/SMARTZONE FEATURES
- MISCELLANEOUS
- INDEX
CONVENTIONAL FEATURES
43
Channel Parameter Programming
Zone Selection
The zone containing the channel to be programmed must be selected
if applicable. To do this, with “RAD PARM” displayed press the key corre-
sponding to the zone containing the channel. Alternatively, press the Up/
Down select switch to scroll through the programmed zones and the “RAD
PARM” selection. The zone selection mode is indicated by “ZONE x”. To
return to “RAD PARM”, press the
F3 key. To proceed to channel param-
eter programming described in the next section, press the
# key.
Channel Selection
The channel to be programmed must be selected. To do this, press
the # key with “ZONE x” displayed as described in the preceding section.
The display then indicates “CHAN xx”. Then to select the desired
channel, press the Up/Down select switch to scroll through the
programmed channels or enter the channel number directly using the
number keys. Disabled or SMARTNET/SmartZone channels cannot be
selected.
To exit back to the “ZONE x” display, press the key with
“CHAN xx” displayed. To save the selection and proceed with the
channel parameter programming described in the next section, press the
F4 or # key.
Channel Parameter Programming
After selecting the channel to be programmed as described in the
preceding section, the following channel parameters can be programmed.
To scroll through these parameters, press the
F4 or # key with “CHAN
xx” displayed. To go back to the previous field, press the key. The
squelch control parameters are unique to the type of conventional channel
selected (analog or Project 25).
Channel Spacing - Selects either “WIDE” or “NARROW” band channel
spacing on analog channels only. Press the Up/Down select switch to
*
*