Operator's Manual
Table Of Contents
- SAFETY TRAINING INFORMATION
- FEATURES
- TABLE OF CONTENTS
- OPTION SWITCH FUNCTIONS
- CONTROLS AND DISPLAY
- GENERAL OPERATION
- CONVENTIONAL FEATURES
- Introduction
- Display Mode Selection
- Monitoring Before Transmitting
- Monitor Mode
- Busy Channel Lockout
- Call Guard Squelch
- Penalty Timer
- Conversation Timer
- Repeater Talk-Around
- Power Output Select
- Emergency Mode (Conventional)
- Conventional Mode Scanning
- Priority Channel Sampling
- Placing and Receiving Standard Conventional Calls
- DTMF/ANI Signaling
- Project 25 Mode Features
- Keypad Programming
- Channel Parameter Programming
- SMARTNET/SMARTZONE FEATURES
- MISCELLANEOUS
- INDEX
CONVENTIONAL FEATURES
45
Transmit NAC - When “NAC xxx” is displayed with the Tx icon
indicated to the left of
Pgm, the receive NAC can be programmed the
same as the Receive NAC described above.
Transmit Power Level - When any of the following indications are
displayed, the power output level for the channel can be programmed.
Press the Up/Down select switch to scroll through the choices. When the
desired setting is displayed, save it and proceed to the next parameter by
pressing the
F4 or # key.
• POWER HI - High transmit power
• POWER LO - Low transmit power
• POWER SW - Switchable power selectable by the High/Low power
switch. This choice is not available if that switch is not
programmed.
Time-Out Timer - When “TOT ON” or “TOT OFF” is displayed, the
time-out timer can be enabled or disabled on the current channel. Press
the Up/Down select switch to toggle between the on and off mode. To
return to the “CHAN xx” display, press the
F4 or # key.
Programming Additional Channels and Exiting Programming Mode
• To program another channel in the current zone, press the F4 or # key
to redisplay “CHAN xx” and then repeat starting with “Channel
Selection” on page 43.
• To program channels in another zone, press the key with “CHAN
xx” displayed to display “ZONE x” and repeat this procedure starting
with “Zone Selection” on page 43.
• If programming is complete, exit the keypad programming mode by
turning power off. Do not turn power on again for a short time to allow
the radio time to copy the settings into memory.
*