Operator's Manual

SMARTNET/SMARTZONE FEATURES
51
Private Conversation II Calls
General
Private calls allow you to place a call to a specific mobile unit.
Either the Enhanced Private Conversation™ or Private Conversation II™
modes may be programmed depending on the capabilities of the radio
system. Operation in the Enhanced Private Conversation mode was
described starting on page 47, and operation in the Private Conversation
II mode is described in the following information.
The Private Call option switch is required to place these calls, and
either that switch or the Call Response option switch is required to
receive them. Proceed as follows.
Placing a Private Conversation II Call
This call can be initiated by selecting the unit ID from a call list (list
entry) or by directly entering it using the keypad (direct entry). Direct
entry is available with full keypad (17-key) models only. Proceed as
follows:
List Entry Method
1. With a SMARTNET/SmartZone channel selected, momentarily press
the Private Call option switch. The tag (alias) of the last ID called is
displayed if it matches an ID in your call list. Otherwise, the last ID
called is displayed.
2. Enter the two-digit index of the desired ID if you know it or scroll
through the list using the Up/Down switch until you find the desired ID.
Press the
F3 key to cancel the call.
3. Press the PTT switch to initiate the call. The display then indicates the
alias of the destination radio. Wait approximately 1 second and then
begin talking. Proceed to the bulleted list which follows the next
method for conditions that may then occur.