Operator's Manual
Table Of Contents
- SAFETY TRAINING INFORMATION
- FEATURES
- TABLE OF CONTENTS
- OPTION SWITCH FUNCTIONS
- CONTROLS AND DISPLAY
- GENERAL OPERATION
- CONVENTIONAL FEATURES
- Introduction
- Display Mode Selection
- Monitoring Before Transmitting
- Monitor Mode
- Busy Channel Lockout
- Call Guard Squelch
- Penalty Timer
- Conversation Timer
- Repeater Talk-Around
- Power Output Select
- Emergency Mode (Conventional)
- Conventional Mode Scanning
- Priority Channel Sampling
- Placing and Receiving Standard Conventional Calls
- DTMF/ANI Signaling
- Project 25 Mode Features
- Keypad Programming
- Channel Parameter Programming
- SMARTNET/SMARTZONE FEATURES
- MISCELLANEOUS
- INDEX
SMARTNET/SMARTZONE FEATURES
58
2. Enter the index of the desired message if you know it or scroll through
the list using the Up/Down switch until you find the desired message.
Press the
F3 key to cancel the message.
3. Press the PTT switch to send the message. When the message is
received and acknowledged by the dispatcher, a signaling success tone
(six beeps) sounds and the display returns to the normal channel indi-
cation. If there is no acknowledgment after 6 seconds, a tone sounds
and “NO ACK” is displayed. Press the
F3 key to return to normal oper-
ation.
Sending Status Conditions
The status feature allows you to send your current status to your
dispatcher. Up to eight status conditions can be preprogrammed, and they
are identified by an alias (name). If the Status option switch is
programmed, status conditions are sent as follows:
1. Momentarily press the Status option switch. The alias of the last status
sent is displayed.
2. To change the displayed status, enter the index of the desired status if
you know it or scroll through the list using the Up/Down switch until
you find the desired status. Press the
F3 key to cancel this function.
3. Press the PTT switch to send the status. When the message is received
and acknowledged by the dispatcher, a signaling success tone (six
beeps) sounds and the display returns to the normal channel indication.
If there is no acknowledgment after 6 seconds, a tone sounds and “NO
ACK” is displayed. Press the
F3 key to return to normal operation.
Emergency Alarm and Emergency Call
Emergency alarms and emergency calls are separate functions that
can be individually programmed on SMARTNET/SmartZone channels.
The Emergency switch is pressed to initiate these features. This switch is
the orange button located next to the antenna connector.