User's Manual

CONVENTIONAL FEATURES
37
desired setting is displayed, store it by pressing the
Select switch.
CHAN SPC (Analog Only) - Selects either wide or
narrow band channel spacing on analog channels only.
Rotate the Select switch to toggle between “WIDE”
and “NARROW”, and when the desired setting is
displayed, store it by pressing the Select switch.
SQ ADJUST (Analog Only) - Changes the preset
squelch setting on that channel. The default setting is
“0” and values of –7 to +7 can be selected. Increasing
this setting toward +7 causes the squelch to open
sooner so that weaker signals can be received, and
decreasing it toward –7 causes the opposite to occur.
NOTE: The channel spacing is not set with P25 chan-
nels because it is always narrow, and the squelch
cannot be changed because the setting is critical for
proper receiver operation.
TG ID (P25 Only) - Selects the talk group for the
selected channel. Rotate the Select switch to display
the alias of each preprogrammed talk group and then
press it to store the desired talk group.
Transmit Type (P25 Mixed Mode Only) - If the
selected channel is a mixed mode, analog and P25
channel, this selects the transmit type. Either Analog
or Digital (P25) can be selected. This then determines
if a Tx Code or Tx NAC is programmed above.