Operating Manual Part 15

6-16 5300 ES Series Mobile Radio Operating Manual October 2008
SMARTNET / SmartZone / P25 Trunked Features
The Control Channel handles all traffic for the radios and communicates which talk groups
are using which channels. If the radio “receives” the ID for one of its talk groups, it can go
to that voice channel and hear the talk group. When the radio is ON the voice channel, it
cannot receive information about which talk groups are on which channel. The radio will
not know about any new talk group activity till it finishes the voice channel and returns to
the Control Channel.
If a Talk Group is set as a Priority Monitor talk group on the system, the system sends the
Talk Group’s call information over a voice channel so it can be detected and move to this
priority call. So even if the radio cannot hear the Control Channel, it will receive the call
information and switch to the channel with the priority call.
Note The Priority Monitor must not be confused with Transmit Priority, which is used when a
call is placed in Queue when all the Voice Channels are busy.
6.11.2 Scan List Editing and Selection
SMARTNET/SmartZone and P25 Trunked scan lists are user programmable if the SCN
ED option switch is programmed (or if the menu parameter is selected). The procedure is
described in Section 4.13.1.
With SMARTNET/SmartZone and P25 trunked operation, each channel (talk group) can
be programmed to select one of the programmed scan lists or so scanning is disabled (No
List). In addition, each channel can be programmed so that scanning is automatically
enabled (Auto Scan) when it is selected. P25 Trunking supports dual priority scan,
therefore two priority talk groups can be selected.
If the SN LIST option switch is programmed (or if the menu parameter is selected), the list
that is selected by all talk groups in the current system can be temporarily changed by the
user as follows. Also selectable if desired is “Programmed” (default list). The temporary
programmed scan list is retained through radio power downs.
Proceed as follows to temporarily change the currently selected scan list:
1 With scanning disabled (the rotating icon is not indicated in the right status display),
press the SN LIST option switch.
2 The currently selected list is displayed as “LIST x”, with “x” the currently selected list.
To exit without changing the selected list, press the SN LIST option switch again.
3 To select another list, “PROGRAMMED”, or “NO LIST”, rotate the Select switch.
When the desired list is displayed, select it and exit this mode by pressing the Scan List
option switch again.