Operating Manual Part 15

6-22 5300 ES Series Mobile Radio Operating Manual October 2008
SMARTNET / SmartZone / P25 Trunked Features
6.14.1 Radio Configuration
The radio must be programmed for data operations on the Trunked IV & D system. The
following parameters apply:
Data Registration On/Off - Enables/disables data registration.
ICMP Echo - Enables the radio to send back an ICMP response once an ICMP request
has been received.
CAI Data Max Tx Attempts - Selects the maximum number of times the radio
attempts to send a CAI data packet. Attempts to send the data packet continue until the
radio receives an acknowledgment confirming the successful receipt of the packet, or
until the radio exceeds the selected amount of transmit attempts.
Response Timer - Selects the period of time the radio waits for an acknowledgment
that a CAI transmission is successful before it tries the transmission again.
SNDCP Activation Wait Timer - Controls the time that a radio waits for the KMF to
respond to a SNDCP context activation request.
Rx Voice Interrupts Data - Enables/disables whether a voice call can interrupt data.
Subscriber IP Address - The IP Address assigned to the subscriber for a PPP
connection.
Mobile Computer IP Address - IP address assigned to the mobile computer for a PPP
connection.
Tx Limited Patience - Selects the amount of time radio attempts to transmit a common
air interface packet. Once time expires, radio ceases transmission. Times are 1 to 255
seconds, infinite in increments of 1. The default is infinite.
Min Response Timer - Selects the minimum amount of time that the radio waits for an
acknowledgement of a successful CAI to be sent across the channel. Times are 50 to
2000 msec., in increments of 50 msec. The default is 700 msec.
Frame Sync Seek Period - Selects the amount of time the radio listens for a frame sync
sequence before a packet is transmitted. Times are 0 to 5000 msec., in increments of 50
msec. The default is 750 msec.
Tx Short Random Range - Selects the maximum amount of time the radio waits to
transmit once the first qualified FS is received indicating the channel is clear. Times are
50 to 500 msec., in increments of 50 The default is 50 msec.
Tx Long Random Range - Selects the upper range of the random range. When the
radio detects a busy, the radio uses a random time within this range (Back off delay) to
determine when to retransmit the packet. Times are 50 to 5000 mSec., in increments of
50 msec. The default is 2000 msec.
Tx Response Random Range - Selects amount of time radio waits before rechecking a
channel's status once a busy channel status symbol has been received. Only applies to
ACKs. Times are 50 to 1000 msec., in increments of 50. The default is 1000 msec.