Operating Manual Part 15

4-14 5300 ES Series Mobile Radio Operating Manual October 2008
Radio Wide Features
4.13.2.2 Editing a Radio Wide Scan List
If the RWS ED option switch is programmed, the radio wide scan list can be edited.
Changes are permanent (cycling power does not reselect a default condition). Proceed as
follows:
1 Make sure that both priority and radio wide scanning are OFF (the rotating icon is
not indicated in the right status display). Select the scan edit mode by pressing the RWS
ED option switch. This mode is indicated by a triangle in the upper left corner of the
display (see Figure 2.3).
2 Select the channel you want to add or delete by rotating the Select switch. A single beep
sounds when the channel is changed (if that option is enabled). After the last channel in
the current zone is displayed, the first valid channel in the next zone is displayed and
vice versa. The list is limited to 16 channels. If an attempt is made to add more than 16,
“LIST FULL” is displayed and a channel must be deleted before another can be added.
3 If the selected channel is in the scan list (scanned), “
R” and the symbol are displayed
next to the zone number. To change the scan list status of the displayed channel, press
the Select switch. A single beep sounds when the switch is pressed (if that option is
enabled).
4 To exit this mode and save the changes, press the RWS ED option switch again.
4.14 Global Positioning System (GPS)
If this feature is enabled, GPS data can be received from satellites when a GPS receiver is
attached to the serial port of the radio. GPS data can be viewed using P25, Conventional,
MultiNet, and SMARTNET/SmartZone Systems.
4.14.1 Viewing GPS Data
To Use the GPS feature (on a properly configured radio):
1 Connect the cable from the GPS receiver to the Serial Port Accessory Cable on the back
of the radio (see Figure 2.2).
2 Press the assigned GPS button (or select GPS from the menu). “No Sat Rec” will
display initially.
3 Wait until the GPS receiver acquires enough satellites to obtain a valid position fix.