Operating Manual Part 15

October 2008 5300 ES Series Mobile Radio Operating Manual 4-15
Radio Wide Features
Note It may take up to 10 minutes, depending upon signal conditions, for the GPS receiver to
obtain a position fix. During this time “No Sat Rec” is displayed. Failure of data to
appear indicates that the receiver was unable to obtain a fix.
When the system acquires a fix, one of the following GPS data items will appear on the
display:
- Latitude (e.g., 40
o
55.32’N)
- Longitude (e.g., 90
o
23.41’W)
- Altitude in meters (e.g., 390.2)
- Speed (e.g., 55.5 MPH)
- Course Over Ground (e.g., COG 183.4
o
)
- Time (e.g., 14:23:15)
- Date (e.g., 26NOV2008)
- Number of satellites that the receiver is currently receiving
4 You can cycle through the data items by turning the Select knob.
- When Time is displayed, you can enter/exit daylight savings time by pressing and
holding the GPS button.
Note The value for each data item is only updated when you move to it. Data of a selected item
is not updated continuously.
Note The GPS viewing mode remains active for 60 seconds after the last user input.
5 To exit GPS viewing, press the assigned GPS button.
4.14.2 Sending GPS Data
The radio can send GPS data in conventional digital mode only. Refer to paragraph 5.16
for more information.