User's Manual

GENERAL OPERATION
15
Revised August 2002
Part No. 001-5300-007CD-NR
3.17.2 RADIO WIDE SCAN LIST
With radio wide scanning, there is only one scan
list and it can include up to 16 channels of any type.
For example, it could include six conventional chan-
nels and ten SMARTNET/SmartZone channels. The
channels in this list are not user programmable.
3.17.3 DETERMINING WHICH CHANNELS ARE
IN SCAN LIST
Channels in the radio wide and conventional stan-
dard scan lists are determined as follows. Channels in
the SMARTNET/SmartZone and P25 Trunked stan-
dard scan lists are indicated only when editing a list.
1. Enable Standard scanning to view the standard list
or Radio Wide scanning to view the radio wide scan
list (the procedure is on page 13). Also select the
scan list if applicable as described in the following
“Selecting a Scan List” description.
2. Select the desired zone and then scroll through the
channels by rotating the Select switch. When the
displayed channel is in the scan list (scanned
normally), the symbol is displayed next to the
zone number as shown in the following illustration.
3.17.4 SELECTING A SCAN LIST
Conventional Operation - The scan list is user select-
able by the
SCAN option switch. Refer to Section 4.11
for more information.
SMARTNET/SmartZone
/P25 Trunked Operation -
The scan list can be temporarily changed if the Scan
(List) Select option switch is programmed. Refer to
Section 5.11 for more information.
3.17.5 EDITING A SCAN LIST
If the SCN ED (Scan Edit) option switch is
programmed, standard scan lists can be user edited as
follows (all operating modes):
1. Make sure that both standard and radio wide scan-
ning are off (the rotating icon is not indicated in
the right status display). Select a conventional,
SMARTNET/SmartZone, or P25 Trunked channel
corresponding to the scan list being edited.
2. Select the scan list edit mode by pressing the
SCN
ED
option switch. This mode is indicated by a
triangle in the upper left corner of the display (see
Figure 2-3 on page 8.).
3. If applicable, select the list to be edited by rotating
and then pressing the Select switch. The selected
scan list is indicated as “LIST x” as described in the
preceding section. If user programming is disabled
on a list, “NO EDIT” is momentarily displayed and
it cannot be edited (conventional channels only).
4. Select the channel you want to add or delete by
rotating the Select switch. After the last channel in
the current zone is displayed, the first valid channel
in the next zone is displayed and vice versa. Lists are
limited to 256 channels. If an attempt is made to add
more than 256, “LIST FULL” is displayed and a
channel must be deleted before another can be
added.
NOTE: A conventional priority channel cannot be
deleted (see Section 4.11.4).
5. If the selected channel is in the scan list (scanned),
the symbol is displayed next to the zone number
as described on page 15. To change the scan list
status of the displayed channel, press the Select
switch.
With conventional channels only, if the selected
scan list is programmed with a fixed priority
channel (see Section 4.11.4), the next press of the
Select switch makes the current channel the priority
channel. The “
P” is then indicated in the left status
display next to the zone number to indicate that it is
a priority channel. Pressing the Select switch again
takes the channel out of the scan list.
6. To exit this mode and save the changes, press the
SCN ED option switch again.
Scan List Indicator
Chnl
No.