User's Manual

SMARTNET/SMARTZONE/P25 TRUNKED FEATURES
31
Revised August 2002
Part No. 001-5300-007CD-NR
• If the access is successful, a dial tone sounds and
the dialed number is displayed and sent. Either
ringing or a busy signal is then heard as with a
standard telephone call. When the called party
answers, press the PTT switch to talk and release it
to listen (since the transceiver operates half-
duplex, it is not possible to talk and listen at the
same time).
Each time the PTT switch is released, a go-ahead
tone is sent to the landside party to indicate when
they can respond. To dial a number after the
connection is made, press the PTT switch and dial
the number using the microphone keypad (if avail-
able).
• If the selected telephone number is not valid,
“INVALID” is displayed and an alert tone sounds.
Select a valid number.
• If the system is busy, “BUSY” is displayed and the
busy tone sounds. The call will automatically
proceed when the system becomes available.
• If you are out-of-range or the radio cannot be
accessed for some reason, “NO PHONE” is
displayed and an alert tone sounds.
• If the interconnect call you are making or the
selected secure mode is not authorized, “REJECT”
is displayed and an alert tone sounds.
• If your transceiver does not have the proper
encryption key, “KEYFAIL” is displayed and the
call must be made in the clear mode by pressing
the
C/S (Clear/Secure) option switch (if encryp-
tion is selectable on the channel). Otherwise, the
correct key must be loaded.
4. When the telephone call is finished or it could not be
completed for some reason, end it by pressing the
PHONE option switch and placing the microphone
back on-hook.
5.5.3 RECEIVING A TELEPHONE CALL
1. When a telephone call is received, “ringing” similar
to a standard telephone is heard and “PHONE” is
displayed.
2. To answer the call, press the
PHONE option switch
and press the PTT switch to talk and release it to
listen (since the transceiver operates half duplex, it
is not possible to talk and listen at the same time).
3. When the call is finished, end it by pressing the
PHONE option switch and placing the microphone
back on-hook.
5.6 CALL ALERT
The Call Alert™ feature allows pages to be sent
and received. With SMARTNET/SmartZone opera-
tion, either the Enhanced Private Conversation™ or
Standard Private Conversation mode may be
programmed depending on the capabilities of the radio
system. With P25 Trunked operation, operation is
similar to the enhanced mode.
Answering a Page
1. When a page is received, four beeps sound and
“PAGE” is displayed. The ID of the mobile paging
you is stored as the last ID received.
2. To clear or ignore the page, press any option switch.
If the PTT switch is pressed, a group call is placed
on the selected channel.
3. To answer the page as a private or unit call (see
page 29), press the
CALL (Private/Unit Call) option
switch and the tag (alias) of the mobile paging you
is displayed. Press the PTT switch and respond. One
of the conditions that follow may also occur:
NOTE: P25 trunked pages operate the same as this
enhanced mode.
E
nhanced Private Conversation™ Mode
• If the mobile being called is on the air, ringing is
heard until the called party answers or for 20
seconds, whichever occurs first. If no answer
occurs within 20 seconds, “NO ANS” is displayed.
• If the mobile being called is not on the air, no
ringing is heard and “NO ACK” is displayed.