User's Manual

SMARTNET/SMARTZONE/P25 TRUNKED FEATURES
32
Revised August 2002
Part No. 001-5300-007CD-NR
Standard Private Conversation Mode
• If the mobile being called is not on the air or does
not answer, you will simply not hear a response.
4. When the call is finished or it could not be
completed for some reason, end it by pressing the
CALL option switch and placing the microphone
back on-hook.
Initiating a Page
1. With a SMARTNET/SmartZone or P25 trunked
channel selected, momentarily press the
ALERT
option switch. The tag (alias) of the last ID called is
displayed.
2. If required, rotate the Select switch to display the
desired mobile. The tag of each number is
displayed.
3. Press the PTT switch and one of the following then
occur:
• If a continuous tone sounds, the system received
the page but the called mobile is not on the air.
Try again later or cancel the page by pressing the
ALERT switch again.
• If the called mobile does not answer within 6
seconds, a continuous tone sounds and “NO
ACK” is displayed. Try again later or cancel the
page by pressing the
ALERT switch again.
• If five beeps sound, the system received the page
and the paged mobile is on the air and received
it. The normal mode is automatically reselected.
5.7 MESSAGING
NOTE: This feature is not available with P25 trunked
operation.
The messaging feature allows preprogrammed
messages to be sent to your dispatcher. Up to 16
messages can be preprogrammed, and they are identi-
fied by a tag (alias). If an
MSG option switch is
programmed, messages are sent as follows:
1. Momentarily press the
MSG option switch. The
alias of the last message sent is displayed.
2. If required, rotate the Select switch to display the
desired message. Then send the message by
momentarily pressing the PTT switch. One of the
following then occurs:
• If five beeps sound and “ACK RCVD” is
displayed, the message was received and automat-
ically acknowledged by the system.
• If after five tries the message is not acknowledged,
a tone sounds and “Unknown Message” is
displayed.
5.8 SENDING STATUS CONDITIONS
The status feature allows you to manually or
automatically send your current status to your
dispatcher. Up to eight status conditions can be prepro-
grammed, and they are identified by a tag (alias). If the
STATUS option switch is programmed, status condi-
tions are sent as follows:
1. Momentarily press the
STATUS option switch. The
tag of the current status condition is displayed.
2. To change the current status, rotate the Select switch
until the desired status is displayed. Then press the
Select switch to accept that status. One of the
following conditions then occurs:
• If five beeps sound and “ACK RCVD” is
displayed, the status was received and acknowl-
edged by the system.
• If after five tries the message is not acknowledged,
a tone sounds and “Unknown Message” is
displayed.
5.9 EMERGENCY ALARM AND EMERGENCY
CALL
Introduction
Emergency Alarms and Calls are separate func-
tions that can be individually enabled or disabled on
each SMARTNET/SmartZone system. The Emergency
option switch is also required for these functions.
Emergency Alarms are transmitted on the last selected
talk group, and Emergency Calls are transmitted on
the emergency talk group programmed on the selected
system.