User's Manual

SMARTNET/SMARTZONE/P25 TRUNKED FEATURES
34
Revised August 2002
Part No. 001-5300-007CD-NR
• If the SCN ED option key is programmed, scan lists
are user programmable (see Section 5.11.3). In addi-
tion, nuisance channels can be temporarily deleted
as described in Section 3.16.6.
• Each talk group is programmed to select one of the
programmed scan lists or “No List” (scanning is
disabled). If scanning is enabled and the selected
channel does not permit scanning, it is automatically
enabled again when a channel is selected that
permits scanning.
• The selected scan list can be temporarily changed if
the Scan (List) Select option switch is programmed.
The procedure is described in Section 5.11.3.
• In addition to calls on channels in the scan list,
pages, private/unit calls, and telephone calls are
received while scanning. Private and telephone calls
are not interrupted by priority messages.
5.11.2 PRIORITY TALK GROUP SAMPLING
One talk group in the scan list can be designated a
priority talk group by programming or it can be the
selected talk group. When scanning, messages on a
non-priority talk group are interrupted by messages on
the priority talk group.
5.11.3 SCAN LIST EDITING AND SELECTION
SMARTNET/SmartZone and P25 Trunked scan
lists are user programmable if the
SCN ED option
switch is programmed. The procedure is described in
Section 3.17.5 on page 15.
SMARTNET/SmartZone and P25 Trunked scan
lists are user selectable if the Scan (List) Select option
switch is programmed. This switch can be used to
temporarily
select another scan list for all talk and
announcement groups in the current system.
“No List” (scanning disabled) or “Programmed”
(default list) can also be selected if desired. Cycling
power returns to the default scan list programmed for
each group. Proceed as follows:
1. With scanning disabled (the rotating icon is not
indicated in the right status display), press the Scan
List option switch.
2. The currently selected list is displayed as “List x”,
with “x” the currently selected list. To exit without
changing the selected list, simply press the Scan List
option switch again.
3. To select another list, “Programmed”, or “No List”,
rotate the Select switch. When the desired list is
displayed, select it and exit this mode by pressing
the Scan List option switch again.
5.12 DYNAMIC REGROUPING
NOTE: This feature is not available with P25
trunked operation.??
The dynamic regrouping feature allows a
dispatcher to switch mobiles to a newly defined
channel to receive an important message. Dynamic
regrouping operates as follows:
1. When this command is received, an alternating tone
and the transceiver automatically changes to the
regrouping channel and “DYN REGRP” is
displayed.
2. Manually select the channel corresponding to that
tag. If this is not done, transmission still occurs on
the new channel, but the alternating tones sound
each time the PTT switch is pressed.
3. Talk and listen as usual. The dispatcher will cancel
dynamic regrouping as indicated by a short tone. If
a standard channel is not selected after this occurs,
an error tone periodically sounds.
5.13 SMARTZONE AND P25 TRUNKING
UNIQUE FEATURES
5.13.1 INTRODUCTION
As described on page 18, the SmartZone
®
mode
provides wide area coverage by allowing roaming
between SMARTNET and conventional sites. The P25
Trunked mode can provide access to a single trunked
site or roaming between several trunked sites. Opera-
tion in these modes is the same as just described in the
preceding sections (5.1-5.12) with the following addi-
tional features: