User's Manual

MISCELLANEOUS

Revised August 2002

Part No. 001-5300-007CD-NR

6.6 LICENSING

A government license is usually required to

operate this transceiver on the air.

6.7 TRANSCEIVER SERVICE

If “UNPROGRAMD” is displayed, the cause

could be any of the following:

• An unprogrammed channel is selected. Select a

programmed channel.

• The selected channel is programmed for an option

that is not installed or an error in programming was

detected. Contact your system operator for service.

If no characters or all characters appear in the

display, the viewing angle may be improperly

adjusted. Refer to Section 3.3 on page 9 for more

information.

If some other problem is occurring, turn power

off and then on again to reset the control logic. Also

make sure that the controls are properly set and that

the power, external speaker, and accessory cables (if

used) are securely plugged into the back of the trans-

ceiver.

If the transceiver is completely inoperative, check

the power cable fuse that is usually located near the

vehicle battery. If it is blown, remedy the cause if

possible and replace it with the same type (15A). If the

transceiver still does not operate properly, return it to

your system operator for service.

NOTE: There are no user-serviceable components in

the transceiver. Altering internal adjustments can cause

illegal emissions, void the warranty, and result in

improper operation that can seriously damage the

transceiver.