ELECTRIC FIREPLACE HEATER MODEL EF-FS1511 OWNERS MANUAL NO VENTILATION REQUIRED PRODUCES SAFE AND EFFICIENT HEAT PLEASE READ THIS ENTIRE MANUAL BEFORE USING UNIT 120 VOLT / 60 Hz / 750 OR 1500-WATT SAVE THIS MANUAL FOR FUTURE USE 1
CONSUMER SARETY INSTRUCTIONS Read this manual before installing and operating this appliance. Failure to follow these instructions may result in electrical shock, property damage, personal injury, and will void the warranty. Do not store or use gasoline, or any other flammable liquids and vapors, in the vicinity of this appliance. Keep this manual for future reference.
13. This heater has hot and potentially sparking parts inside. Do not use the heater in any areas where gasoline, paint, or any other flammable materials are used or stored. 14. Place this heater near a wall outlet so an extension cord is not needed. If an extension cord is necessary, the gauge of the cord must be at least 14AWG, and the rating must be at least 1875-watts. Never use a smaller gauge cord with a lower rating. Doing so may result in electric shock or fire. 15.
PREPERATION • • • • • Remove all parts and hardware from the carton and place them on a clean, soft, and dry surface. Make sure all parts are dry, and that the power cord and plug are not damaged. Compare the contents with the parts list to make sure nothing is missing. Dispose of all packaging materials properly. Please recycle whenever possible. ASSEMBLY ALWAYS make sure the unit is unplugged before beginning assembly. NEVER move or clean the heater, or change the bulbs, while it is plugged in.
OPERATION NOTICE When the heat function is used for the first time, a slight odor may be present. This is normal and should not occur again unless the heater is not used for an extended period of time. BUTTON ACTION/FUNCTION DIMMING DIAL 1. Slide dial to right or left until you reach the desired flame brightness 1. This dial allows you to adjust the brightness of the flame effect depending on your preference. 1. Press to turn on the flame effect and enable heater.
TEMPERATURE LIMITING CONTROL This heater is equipped with Temperature Limiting Control. Should the heater reach an unsafe temperature (212 degrees F / 100 degrees C), the heater will automatically turn off. To reset: 1. 2. 3. 4. Unplug the power cord from the outlet. Turn the ON/OFF switch on the control panel to OFF. Wait 5 minutes. Inspect the electric fireplace to make sure that no vents are blocked, or clogged with dust or lint. If they are, use a vacuum to clean the vent areas. 5.
MAINTENANCE Risk of electric shock! DO NOT OPEN the main panels! There are no serviceable parts inside (except for lightbulbs). Storage: Store heater in a clean and dry place when not in use. Electric and Moving Parts: The fan and motors are lubricated at the factory, and will not require lubrication for the life of the stove. Except for the lightbulbs, all electrical parts and components are integrated into the heater, and are not serviceable by the consumer.
LIMITED WARRANTY This warrants to the original purchaser that this product is free from defects in material and workmanship as of the date of purchase and that it will, under normal use and proper care, remain so for 1 year from the date of purchase. Missing or initially defective parts will be replaced free of charge during the period of this limited warranty. If parts are unavailable, comparable replacement or refund will be given. The original dated sales receipt is required for all warranty claims.