Adagio™ 280 Instruction Manual Bedienungsanleitung Manuel d’utilisation Manuale di Istruzioni
EN NOTICE All instructions, warranties and other collateral documents are subject to change at the sole discretion of Horizon Hobby, LLC. For up-to-date product literature, visit www.horizonhobby.com and click on the support tab for this product.
EN Box Contents Table of Contents Preflight Checklist .................................................4 Wing Installation ...................................................4 Horizontal Tail Installation .....................................5 Low Voltage Cutoff (LVC) .......................................5 Transmitter and Receiver Binding .........................6 Battery Installation ................................................7 ESC Arming ..........................................................
EN Preflight Checklist 9 9 1. Charge flight battery. 6. Adjust center of gravity. 2. Install flight battery in aircraft (once it has been fully charged). 7. Perform a radio system Range Check. 3. Bind aircraft to transmitter. 8. Find a safe and open area. 4. Make sure linkages move freely. 9. Plan flight for flying field conditions. 5. Perform Control Direction Test with transmitter. Wing Installation 1. Remove the canopy hatch before installing the wings. 2. Slide the wing tube (A) into the fuselage.
EN Horizontal Tail Installation Required Adhesives: Medium CA 1. Apply a small amount of CA (cyanoacrylate adhesive) glue to the channel in the top of the horizontal tail. IMPORTANT: Keep glue away from the elevator hinge. 2. Insert the tail wheel housing and the tail in the slots in the rear of the fuselage. 3. Connect the elevator clevis (A) to the control horn (B). Refer to the Control Horn and Servo Arm Settings for correct connection.
EN Transmitter and Receiver Binding Binding is the process of programming the receiver to recognize the GUID (Globally Unique Identifier) code of a single specific transmitter. You need to ‘bind’ your chosen Spektrum™ DSM2/DSMX technology equipped aircraft transmitter to the receiver for proper operation. Any full range Spektrum DSM2/DSMX transmitter can bind to the DSM2/DSMX receiver. Please visit www.bindnfly.com for a complete list of compatible transmitters.
EN Battery Installation 1. Remove the canopy. 2. Apply the included loop tape to the bottom of the battery. 3. Install the battery (A) in the battery cavity towards the front of the fuselage. Refer to the Center of Gravity instructions for the battery’s position. 4. Connect the fully charged flight battery to the ESC. Refer to the ESC Arming instructions for correct connection of the battery to the ESC. 5. Replace the canopy on the fuselage.
EN Control Direction Test Bind your aircraft and transmitter before doing these tests. Move the controls on the transmitter to make sure the aircraft control surfaces move correctly and in the proper direction. Always keep throttle at the low position during testing. Make sure the tail linkages move freely and that paint or decals are not adhered to them. Control Centering Before the first flights, or in the event of an accident, make sure the flight control surfaces are centered.
EN Dual Rates High Rate Dual Rates We recommend using a DSM2/DSMX radio capable of dual rates. The settings to the right are recommended starting settings for intermediate pilots. Adjust according to individual preferences after the initial flight. Aileron 14mm Elevator 8mm / / Rudder 16mm / Low Rate 10mm / 6mm / 12mm / Flaps Tip: For the first flight, fly the model at LOW RATE.
EN Flying Tips and Repairs Consult local laws and ordinances before choosing a location to fly your aircraft. We recommend flying your aircraft outside in no greater than moderate winds. Always avoid flying near houses, trees, wires and buildings. You should also be careful to avoid flying in areas where there are many people, such as busy parks, schoolyards or soccer fields. Range Check Your Radio System After final assembly, range check the radio system with the aircraft.
EN Post Flight Checklist 9 9 1. Disconnect flight battery from ESC (Required for safety and battery life). 5. Store flight battery apart from aircraft and monitor the battery charge. 2. Power off transmitter. 6. Make note of flight conditions and flight plan results, planning for future flights. 3. Remove flight battery from aircraft. 4. Recharge flight battery. Service of Power Components Disassembly CAUTION: Always disconnect the battery before handling or adjusting the propeller or motor.
EN Troubleshooting Guide Problem Possible Cause Aircraft will not respond to throttle but responds to other controls ESC did not arm because throttle stick and/or throttle trim too high Throttle channel is reversed Motor disconnected from ESC Servo travel setup is less than 100% Extra propeller noise or extra vibration Damaged propeller, spinner or motor Prop nut is too loose Prop is out of balance Spinner is not tight or fully seated in place Reduced flight time or aircraft underpowered Flight batte
EN Limited Warranty What this Warranty Covers Horizon Hobby, LLC (“Horizon”) warrants to the original purchaser that the product purchased (the “Product”) will be free from defects in materials and workmanship at the date of purchase.
EN If received, a non-compliant Product will not be serviced. Further, the sender will be responsible for arranging return shipment of the un-serviced Product, through a carrier of the sender’s choice and at the sender’s expense. Horizon will hold non-compliant Product for a period of 60 days from notification, after which it will be discarded.
Replacement Parts – Ersatzteile – – Pièces de rechange – Pezzi di ricambio – Part # • Nummer Numéro • Codice Description Beschreibung Description Descrizione EFL6501 Horizontal Stab: Adagio 280 E-flite Adagio 280: Höhenleitwerk m. Rad Horizontal Stabilisateur: Adagio 280 Stabilizzatore orizzontale: Adagio 280 EFL6502 Hatch: Adagio 280 E-flite Adagio 280: Haube Trappe: Adagio 280 Portello: Adagio 280 EFL6503 Prop and Spinner: Adagio 280 E-flite Adagio 280: Klapp-Propeller u.
– Optional Parts and Accessories – – Optionale Bauteile und Zubehörteile – – Pièces optionnelles et accessoires – – Parti opzionali e accessori – Part # • Nummer Description Numéro • Codice Beschreibung Description Descrizione EFLA230 Charger Lead with JST Female E-flite Ladekabel m/ JST Buchse Câble de charge avec prise JST femelle Cavo di carica con femmina JST EFLA250 Park Flyer Tool Assortment, 5 pc Park Flyer Werkzeugsortiment, 5 teilig Assortiment d’outils park flyer, 5pc Park Flyer assorti
© 2014 Horizon Hobby, LLC. E-flite, Adagio, Prophet, DSM, DSM2, DSMX, AS3X, ModelMatch, and the BNF logo are trademarks or registered trademarks of Horizon Hobby, LLC. The Spektrum trademark is used with permission of Bachmann Industries, Inc. The trim scheme of the Adagio was designed by Mirco Pecorari of Aircraft Studio Design. Futaba is a registered trademark of Futaba Denshi Kogyo Kabushiki Kaisha Corporation of Japan. Patents pending. www.e-fliterc.