Owner manual

20 E-flite Apprentice PNP Assembly Manual
High Rate: 1
-
inch (25mm) (Up and Down)
AILERON THROW
 5. Use a ruler to check the control throws on the
ailerons. The dimensions are shown below. For
your reference the aileron pushrods are set up in
the following holes: the outside hole on the aileron
control horn and the outside hole on the aileron
servo arm.
Low Rate: 3/8-inch (9mm) (Up and Down)
High Rate: 5/8-inch (16mm) (Up and Down)
 6. Once all the control throws have been set, make
sure to slide the clevis retainers over the clevises to
prevent them from opening accidentally.
 7. For your reference, the nose wheel steering
pushrod is set up in the following holes: the fixed
position hole on the nose wheel steering arm and
the outside hole on the rudder servo arm.
Installing the Propeller
Required Parts
Fuselage assembly Propeller
Propeller nut Propeller washer
Spinner cone Spinner backplate
Washer
Required Tools
Adjustable wrench
Before performing any maintenance to the motor,
make sure the battery has been unplugged and
removed from your model to prevent injury.
 1. Slide the propeller on the propeller adapter.