Owner manual

4 E-flite Apprentice PNP Assembly Manual
AR6200 Receiver Installation
Required Parts
Fuselage assembly Hook and loop tape
AR6200 Receiver with remote receiver
 1. Attach a piece of hook and loop material to the
back of the main receiver. Insert the receiver into
the pre-formed pocket in the fuselage as shown.
 2. Attach a piece of hook and loop material to
the back of the remote receiver. Mount the remote
receiver on the left side of the fuselage (as viewed
if sitting in the aircraft) as shown. The antennas
should be vertical on the remote receiver as shown
in the photo.
 3. Plug the leads from the speed control, rudder
servo and elevator servo into the appropriate ports
of the receiver. Note the rudder servo is larger, and
the elevator servo is smaller.
Tail Installation
Required Parts
Fuselage assembly Stabilizer/Elevator
Fin/Rudder
2.5mm x 12mm sheet metal screw (2)
Required Tools
Phillips screwdriver: #1
 1. Position the stabilizer on the fuselage. Align the
holes in the stabilizer with the holes in the rear of
the fuselage. The decals on the stabilizer will face
toward the top of the fuselage.