User Manual

EN
Post Flight
NOTICE: When you are finished flying, never keep the aircraft in the sun. Do not
store the aircraft in a hot, enclosed area such as a car. Doing so can damage the
foam.

Post Flight Checklist
1. Turn off ESC switch
2. Power off transmitter
3. Remove flight battery from aircraft
4. Recharge flight battery
5. Repair or replace all damaged parts
6. Store flight battery apart from aircraft and monitor the battery
charge
7. Make note of flight conditions and flight plan results, planning for
future flights
Service and Repairs
NOTICE: After any impact or replacement, always ensure the receiver is secure
in the fuselage. If you replace the receiver, install the new receiver in the
same orientation and manner as the original receiver or damage may result.
Thanks to the Z-Foam™ material in the wing and fuselage of this aircraft,
repairs to the foam can be made using virtually any adhesive (hot glue, regular
CA (cyanoacrylate adhesive), epoxy, etc). However, use only foam-compatible
CA, foam-compatible accelerant or epoxy on the vertical and horizontal tail
material.
When parts are not repairable, see the Replacement Parts List for ordering by
item number. For a listing of all replacement and optional parts, refer to the list
at the back of this manual.
20