User Manual

  8. Slide a .045" x 12
5
/
8
" (1.15mm x 320mm)
carbon rod from the center of the bottom wing to
the top wing near the strut. Leave at least 1/16"
(1.5mm) of the rod exposed at both ends. Glue
the rod only at the fuselage. Apply foam-safe CA
to the rod both at the inside and outside in order
to capture the rod in position.
  9. Place the top wing on a surface that will allow
the wing panel to lie perfectly flat. Apply glue to
the inside edge of the rod. Once the glue fully
cures, carefully lift the airframe and apply CA to
the top of the rod.
 10. Repeat Steps 8 and 9 for the opposite side.
14