EFL5150 Clipped Wing Cub Manual

EN
Clipped Wing Cub
Only use the oats if you are comfortable ying your aircraft and have repeatedly
taken off, own and landed with success. Flying off water poses a higher risk to
the airplane because the electronics can fail if fully immersed in water.
To take off on water, steer with the rudder and slowly increase the throttle.
Keep the wings level on takeoff. Hold a small amount (1/4–1/3) of up
elevator and the aircraft will lift off once ying speed is reached.
To land this aircraft on water, y the aircraft to a couple of feet off the surface
of the water. Reduce throttle and add up elevator to are the aircraft.
When taxiing, you must use throttle to move the aircraft forward, but steer with
the rudder stick.
Avoid taxiing cross wind if there is a breeze, as this can cause the aircraft to
ip over if wind gets under the upwind wing. Taxi 45 degrees into the direction
of the wind (not perpendicular to the wind) and use aileron to hold the upwind
wing down. The aircraft will naturally try to face into the wind when taxiing.
Always fully dry the aircraft after landing on water.
CAUTION: Never go alone to get a downed model in the water.
CAUTION: If at any time water splashes in the fuselage while ying
from water, bring the airplane to shore, open the battery hatch and
immediately remove any water that may have gotten in the fuselage. Leave the
battery hatch open overnight to let the inside dry out and to prevent moisture
damage to the electronic components. Failure to do so could cause the
electronic components to fail, which could result in a crash.
Flying Tips and Repairs Continued
Water Takeoff and Landing Using the Optional Float Set
45º
Up Aileron
Down Aileron
Wind
Taxi 45 degrees into the direction of the wind.
PNP Receiver Selection and Installation
The Spektrum AR636 receiver is recommended for ths airplane. If you choose
to install another receiver, ensure that it is at least a 4-channel full range
(sport) receiver. Refer to your receiver manual for correct installation and
operation instructions.
Installation (AR636 shown)
1. Remove the canopy and wing from the fuselage.
2. Mount the receiver parallel to the length of the fuselage as shown. Use
double-sided servo tape.
CAUTION: Incorrect installation of the receiver could cause a crash.
3. Attach the appropriate control surfaces to the their respective ports on the
receiver using the chart in the illustration.
1 = Throttle
2 = Aileron
3 = Elevator
4 = Rudder
5 = NA
6 = NA
SAFE Select Flying
SAFE Select will automatically compensate for pitch up with throttle
application and aps deployed.
During takeoff, apply throttle and hold up some up elevator for short takeoffs.
Once the desired pitch attitude is reached, hold that amount of elevator. Once
the elevator stick is returned to center, the aircraft will automatically resume
level ight. If not doing a short takeoff, apply throttle, let the tail come up,
gently apply up elevator and allow the plane to y off the ground.
For landing, use the elevator and throttle to adjust your glideslope to the
desired landing point. Once at the landing point, just above the ground, reduce
throttle and are.
14