EFL5150 Clipped Wing Cub Manual

Clipped Wing Cub

Model Assembly Continued

Horizontal Tail Installation

1. Slide the horizontal tail tube (A) into the hole in the rear of the fuselage.

2. Install the 2 piece (left and right) horizontal tail as shown. Ensure the

control horn faces down.

3. Secure the two horizontal tail pieces in place using the

2 included screws (B).

4. Attach the clevis to the elevator control horn (see instructions for

clevis connection).

Clevis Installation

• Slide the connector over the “L” bend in the control rod as shown in (A).

• Rotate the connector up until it snaps onto the control rod (B).

Control Surface Centering

After assembly and transmitter setup, conrm that the control surfaces are

centered. If the control surfaces are not centered, mechanically center the

control surfaces by adjusting the linkages.

• Loosen the screw on the connector attached to the servo horn.

• Slide the control rod in or out until the control surface is centered.

• Tighten the connector screw when nished.