EFL5150 Clipped Wing Cub Manual

Model Assembly Continued

Wing Installation

1. Connect the Aileron connectors from the wing to the respective

Y-harnesses connectors from the receiver. The left and right servos

can be connected to either side of a Y-harness.

IMPORTANT: The ailerons must be connected to the receiver’s AILE

(#2 channel) with a Y-harness (included) for the AS3X

system to function

properly.

CAUTION: DO NOT crush or otherwise damage the wiring when

attaching the wing to the fuselage.

2. Align the wing with the fuselage and secure it into position using 1 nylon

wing bolt (A). No tools required.

3. Attach the wing struts from each wing onto the wing strut tabs mounted on

the bottom of the fuselage.

4. Secure the wing struts by rotating the locking pin (B) into position as shown and

tighten with a small Phillips screwdriver.

Disassemble in reverse order.

Ailerons