EFL5150 Clipped Wing Cub Manual

Clipped Wing Cub

Model Assembly Continued

Float Installation (Optional)

Float Assembly

1. Install the 2 cross members (A) to the left and right oats as shown.

2. Install the front and rear oat struts to the oats and secure the assembly

together using the included 4 oat plates (B) and screws (C). The front strut

has slightly more of an angle than the rear strut (Figure 1).

3. Install the front support members (D) as shown using the included

screws (E).

Float Assembly Installation

1. Align and mount the oat set assembly to the bottom of the fuselage.

2. Secure the back section of the oats to the fuselage using the included

bracket (F) and 2 screws (G).

3. Secure the front section of the oats using the two included screws (H) to

secure the front support members to the bottom of the fuselage.

Disassemble in reverse order.

D E

Fig. 1

Front Strut