EFL11050 Convergence VTOL Manual

EN
4
Model Assembly
Install the Vertical Fins
Install the vertical fi ns on the fuselage using two screws per side as shown.
Install the Main Propellers
The main propellers are labelled near the hub with an “R” and an “L” to
show on which side they should be installed.
1. Find the propeller collets, backplates and nuts.
2. Place a collet over the right side motor shaft as shown.
3. Slide a backplate over the collet.
4. Place the propeller marked “R” over the collet, with the “R” facing away
from the motor.
5. Install the propeller nut on the collet. Use a small screwdriver or hex
wrench through the hole in the propeller nut to tighten. Do not overtighten
the propeller nut as damage to the propeller, nut or collet may occur.
6. Repeat steps 1-5 for the left motor using the propeller marked “L”.
Prefl ight
1. Remove and inspect contents.
2. Read this instruction manual thoroughly.
3. Charge the fl ight battery.
4. Setup Transmitter using transmitter setup chart.
5. Fully assemble the airplane.
6. Install the fl ight battery in the aircraft (once it has been fully charged).
7. Check the Center of Gravity (CG).
8. Bind the aircraft to your transmitter.
9. Make sure linkages move freely.
10. Perform the Control Direction Test with the transmitter.
11. Perform the stability system control direction test with the aircraft.
12. Adjust fl ight controls and transmitter.
13. Perform a radio system Range Test.
14. Find a safe open area to fl y.
15. Plan fl ight for fl ying fi eld conditions.
Transmitter Setup
The Convergence
™
aircraft requires a transmitter with a minimum of 6
channels and 2 open two-position switches.
Flight Modes are controlled by channel 5.
The transition from vertical fl ight to forward fl ight is controlled by channel 6.
IMPORTANT: After you set up your model, always rebind the transmitter and
receiver to set the desired failsafe positions.
Expo
After the fi rst few fl ights, you may adjust expo up or down in your transmitter
to better suit your fl ying style.
Computerized Transmitter Setup
(DXe*, DX6e, DX6, DX7 (Gen2), DX8 (Gen2), DX9, DX18 and DX20)
Start all transmitter programming with a blank ACRO model (perform a model
reset), then name the model.
Set Expo values to
Elevator 25%
Aileron 25%
Rudder 0%
Set Servo Travel to 100%
DX6 (Gen2)
DX7 (Gen2)
DX8 (Gen2)
DX9
DX18
DX20
1. Go to the SYSTEM SETUP
2. Set MODEL TYPE: AIRPLANE
3. Set AICRAFT TYPE:
WING: NORMAL
4. Set CHANNEL ASSIGN: (NEXT)
CHANNEL INPUT CONFIG: GEAR: A
AUX1: H
* To download the DXe Convergence
™
setup, visit www.spektrumrc.com.