EFL11050 Convergence VTOL Manual

Battery Installation and ESC Arming

Battery Selection

We recommend the E-ﬂ ite

2200mAh 11.1V 3S 30C Li-Po battery

(EFLB22003S30). Refer to the Optional Parts list for other recommended

batteries. If using a battery other than those listed, the battery should be within

the range of capacity, dimensions and weight of the E-ﬂ ite Li-Po battery packs

to ﬁ t in the fuselage.

1. Lower the throttle and throttle trim to the lowest settings. Set the ﬂ ight

attitude switch to multirotor ﬂ ight. Power on the transmitter and wait

approximately 5 seconds.

2. Carefully lift the back of the battery hatch and pull back to remove it.

3. For added security, apply the loop side (soft side) of the optional hook and

loop tape to the bottom of your battery and the hook side to the battery tray.

4. Install the fully charged battery in the battery compartment as shown.

Secure using the hook and loop strap.

5. Connect the battery to the ﬂ ight controller.

6. Keep the aircraft upright, immobile and away from wind or the system will

not initialize.

• The motor nacelles will rotate to the middle position brieﬂ y and then to

the upright, multirotor ﬂ ight position, indicating the ﬂ ight controller has

initialized and the ESCs are armed.

CAUTION: Always keep hands away from the propeller. When armed,

the motor will turn the propeller in response to any throttle movement.

7. Reinstall the battery hatch.

8. Refer to the Center of Gravity section to ensure the model balances at the

recommended CG.