A-10 Thunderbolt II Twin 64mm EDF - Manual

Vertical Fin Installation

1. Connect the rudder servo connector to the extension in the horizontal

stabilizer. Secure the connection with tape.

2. Apply the decal over the servo and servo wire as shown. Feed the excess servo

wire into the pocket at the end of the horizontal stabilizer.

3. Apply medium CA to all joining surfaces of the left vertical  n, press into

place and allow to cure. Ensure that the vertical  n is perpendicular to the

horizontal stabilizer.

4. Install the right vertical  n onto the opposite side of the horizontal tail

following the previous steps.

Model Assembly (Continued)