User Manual

EN
11
Re-Connecting The Swing Wing Linkage
The wing sweep mechanism is designed to disengage and prevent damage in the
event of an impact on the wing. In the event the wing swing mechanism becomes
disengaged, the linkage needs to be re-connected to the wing.
To re-connect the wing(s):
1. Remove the bottom fuselage cover from the bottom of the aircraft.
2. Use a magnetized screwdriver to remove the four screws from the bottom of
the aircraft that hold the top fuselage cover.
3. Lift at the rear of the top fuselage cover and pull rearward to disengage the
clips at the front of the cover, then remove the cover.
4. Power your transmitter and the aircraft ON and move the wing swing
mechanism to the wings fully out position.
5. Snap the wing swing linkage back together.
6. Verify the wing swing mechanism is working correctly.
7. Replace the top cover. Insert the two clips at the leading edge of the cover into
their respective slots in the fuselage and ensure the hatch is moved forward to
fully engage the clips.
8. Reinstall the screws for the top fuselage cover; tighten the front screws rst,
and then the rear.
9. Reinstall the bottom fuselage cover.
10. Verify the wing swing mechanism is working correctly.
1. Disconnect the ight battery from the ESC (required for safety and battery life).
2. Power OFF the transmitter.
3. Remove the ight battery from the aircraft.
4. Recharge the ight battery to storage voltage level.
5. Repair or replace all damaged parts.
6. Store the ight battery apart from the aircraft and monitor the battery charge.
7. Make note of the ight conditions and ight plan results, planning for future ights.
Post Flight