User Manual

CAUTION: Always disconnect the ight battery before performing motor
service.
EN
13
Power System Installation and Service
The recommended power system components are given in the Specications table
at the beginning of this manual.
1. Use a fresh hobby knife to cut along the glue seam for the lower rear fan
ducting to reveal the ducted fan unit.
2. The fan unit is glued in place, remove it by gently twisting the fan enclosure.
3. Repair or replace the fan parts as necessary.
4. Reinstall the fan with a small dab of medium or thick CA glue; the fan
enclosure is captured in the foam which provides most of the mounting
strength.
5. Install the fan enclosure with small dabs of medium or thick CA glue
along the fore/aft seam and along the leading edge of the part.
Replacing a Vertical Stabilizer
In the event the vertical stabilizer(s) needs maintenance, the stabilizer will need to
be removed so the replacement can be installed.
To replace the vertical stabilizer(s):
1. Use a fresh hobby knife to cut out any vertical stabilizer material from the
mounting location.
2. Secure the new vertical stabilizer in place with thick CA.
3. Be prepared to wipe off any excess glue with a paper towel when you press
the stabilizer into place.