User Manual

EN
5
WARNING: Before proceeding, remove the spinner and propeller from the motor shaft. Never attempt to
program the radio components, assemble the aircraft or perform maintenance of any kind without
removing the propeller or engaging throttle cut. Serious injury could result if the motor starts inadvertently with
the propeller still attached.
Model Assembly
Horizontal Stabilizer Installation
1. Slide the horizontal stabilizer joiner into the hole in the rear of the fuselage.
2. Flex each of the elevators up and down several times to ensure the hinge allows
the elevators to move freely.
3. Install the two piece (left and right) horizontal stabilizer as shown. Ensure the
control horn faces down, and the elevator joiner engages.
4. Secure the horizontal stabilizer pieces in place using the two included 2.6 x 12 mm
self tapping screws.
2.6 x 12mm
self-tapping
counter sunk