User Manual

RV-7 1.1m



Receiver Selection and Installation PNP

AR631 Port Assignments

BND/PRG = BIND/Lights

1 = Throttle

2 = Ailerons

3 = Elevator

4 = Rudder

5 = N/A

6 = Flaps

The recommended receiver for this aircraft is the Spektrum AR631. If you choose to

install a different receiver, ensure that it is at least a 6-channel full range receiver.

Refer to the manual of your chosen receiver for correct installation and operation

instructions.

AR631 Installation

1. Connect the servos to the their respective ports in the receiver using the table

at the right.

2. Using high quality double-sided servo tape,(not included) mount the receiver to

the ﬂat area behind the battery compartment, as shown. The receiver should

be mounted in the orientation shown, parallel to the length of the fuselage,

with the label facing up and the servo ports facing the front of the aircraft. The

orientation of the receiver is critical for all AS3X and SAFE technology setups.

CAUTION: Incorrect installation of the receiver could cause a crash.

Antenna Installation

The AR631 receiver has a coaxial style antenna. We recommend installing the

antenna as shown in the illustration and as far as possible from metal, batteries, or

carbon ﬁber to maximize signal reception performance.

NOTICE: Do not cut, kink, or modify the antenna. Damage to the coaxial portion

of an antenna will reduce the performance of the antenna. Shortening or cutting

off the 31mm tip will reduce the range.

Active portion

of antenna

Step Installation (optional)

The aircraft includes step(s) detail and/or plug(s) which can be used instead.

1. Select either the steps or plugs.

2. Apply a small amount of medium CA glue and press into place.