User Manual

EN
11
Receiver Wiring Diagram
Reference the following diagram for all wiring
connections to the receiver.
Part # Description
EFL02205 LED Set: Ultrix 600mm
IC2 battery connector
Bottom View Of Airplane
Looking At The Receiver
Points to nose
of the aircraft
Optional wing lights
Left Elevon Servo
Update Port
Right Elevon Servo
Gyro Port
Problem Possible Cause Solution
Control surfaces not at neutral
position when transmitter
controls are at neutral
Control surfaces not mechanically centered
from factory
Center control surfaces mechanically by
adjusting the U-bends on control linkages
Aircraft was moved after the flight battery
was connected and before sensors initialized
Disconnect and reconnect the flight battery
while keeping the aircraft still for 5 seconds
Model flies inconsistently
from flight to flight
Trims are moved too far from neutral position
Neutralize trims and mechanically adjust
linkages to center control surfaces
Controls oscillate in flight
(model rapidly jumps or moves)
Propeller is unbalanced,
causing excessive vibration
Remove propeller and motor. Check motor
shaft for straightness and replace prop if
damaged
Recommended Parts List
Optional Parts
AS3X Troubleshooting Guide
Part # Description
SPMX8503S30 850mAh 3S Smart G2 30C; IC2
SPMXC1080 Smart S1100 AC Charger, 1x100W
SPMXCA320 Adapter: IC3 Batt / IC2 Dev 6
Part # Description
A EFL02201 Replacement Airframe: Ultrix 600mm
B EFL02202 Vertical Fin Set: Ultrix 600mm
C EFL02203 Pushrod/Nosewheel: Ultrix 600mm
D EFL02204 Battery Hatch: Ultrix 600mm
E SPMA3255 RX/ESC Unit: Ultrix 600mm
F
SPMSH2040LW 2.9g Linear Long Throw Servo
G SPMXAM2000 1206-3900Kv Motor: Ultrix 600mm
H EFLP9448 Prop Set (4): Ultrix 600mm