User Manual

10
EN
Habu SS 70mm EDF
Choose a Flying Field
Consult local laws and ordinances before choosing a location to y your aircraft.
In order to have the most success and to protect your property and aircraft, it is
very important to select a place to fly that is very open.
Remember, your aircraft can reach significant speeds when flying and can
cover ground quickly. Plan on flying in an area that gives you more space than
you think you need, especially with first flights.
The flying site should:
• Have a minimum of approximately 1300 feet
(400m) of clear space in all directions.
• Be clear of people and pets.
• Be free of trees, buildings, cars, power lines or anything that could
entangle your aircraft or interfere with your line of sight.
During your first flight, trim the aircraft for your flying style in AS3X flight mode.
Flight trim is usually performed between 70–100% power setting, per your
preference. Make small trim adjustments with your transmitter’s trim switches
to straighten the aircraft’s flight path.
After adjusting the trim, do not touch the control sticks for 3 seconds. This
allows the receiver to learn the correct settings to optimize AS3X performance.
Failure to do so could affect flight performance.
In Flight Trimming BNF
3 Seconds
Low Rate High Rate
Aileron 15mm 20mm
Elevator
10mm ▲ / 7mm▼ 13mm ▲ / 10mm ▼
Rudder 18mm 22mm
Program your transmitter to set the rates and control throws based on your
experience level. These values have been tested and are a good starting point
to achieve a successful first flight.
After flying, you may choose to adjust the values for the desired control
response.
Dual Rates and Control Throws
AS3X Control Response Test BNF
This test ensures that the AS3X control system is functioning properly.
Assemble the aircraft and bind your transmitter to the receiver before
performing this test.
1. Raise the throttle to any setting above 25%, then lower the throttle to
activate AS3X technology.
CAUTION: Keep all body parts, hair and loose clothing away from the
intake ducts as these items could become entangled.
2. Move the entire aircraft as shown and ensure the control surfaces move in
the direction indicated in the graphic. If the control surfaces do not respond
as shown, do not fly the aircraft. Refer to the receiver manual for more
information or visit www.SpektrumRC.com.
Once the AS3X system is active, control surfaces may move rapidly. This is
normal. AS3X remains active until the battery is disconnected.
Aircraft Movement AS3X Reaction
PitchRollYaw